MTHTrains 4-6-0 Steam Freight/Passenger Set Operations Instructions download pdf (Page 7)

RailKing 4-6-0 Steam Freight/Passenger Set with Proto-Sound® 3.0

Connecting the Transformer & Installing DCS Remote

Commander Set

Your set comes with M.T.H.'s latest DCS System, the DCS Remote Commander.

The DCS Remote Commander includes a handheld Remote which communicates

with a Receiver powered by a UL approved Transformer to provide an easy-to-use,

safe power source for your new train set. To install the DCS Remote Commander

and Transformer please use the following instructions:

1. Ensure the Z-500 transformer is unplugged.

2. Install two AA batteries (not included) into the Remote. You will need a small

screw driver.

3. Plug the Z-500 transformer barrel jack into the port labeled “Power” on the

Receiver. Using the RealTrax Wire Harness plug the color-coded wires from the

Receiver to the Lighted Lock-on.

4. Make sure that the engine and cars are properly assembled and coupled on the

track and then plug the Z-500 transformer into any 110 volt AC wall outlet. You

will know that you have power to the receiver and the track if you see the green

LED atop the Receiver and the green light atop the Lighted Lock-on will come on.

Subsequent pushes of any buttons on the remote will cause the green LED atop

the Receiver to blink, indicating it is receiving the signal.

See Illustrations Below

Red Harness

Wire/Plug

Black Harness

Wire/Plug

Lighted Lock-on

Receiver

Z-500 Transformer

Remote

Red Harness

Wire/Plug

Black Harness

Wire/Plug

1 2 3 4 5 6 7 8 9 10 11 12 ... 57 58

No comments

MTHTrains 4-6-0 Steam Freight/Passenger Set Operations Instructions Page 7